Filter
Top Products
Product Description AXIS 250S User’s Manual
8
Product Description
Read the following information to familiarize yourself with the AXIS 250S, making
particular note of where the connectors and indicators are located.
AXIS 250S Front Panel
AXIS 250S Rear Panel
❶Factory Default Button
- Press this button to
restore the factory default
settings, as described on
page 34.
❷Microphone Connector
❸Line Connector
❹Y/C Video Input (S-Video) - Physical connections
made using s-video cable.
❺Switch for selecting 75 ohm video termination (for BNC). Usually set to ON.
❻ Video Input (BNC) - coax/BNC connector. Connections using RG59, 75 Ohm coax video cable have a recommended maximum
length of 800 feet (250 meters).
❺
❻
❹❸❷
❶
❹
❶
❸
❺
❻
❷
❶
I/O Terminal Block A -
Provides the physical inter-
faces to one transistor out-
put, two digital inputs, and
GND. Used for connecting
external devices typically
associated with CCTV
equipment. See also page
46.
❷Power Supply Connector - A single socket (PS-K) for connection of the
AXIS 250S power supply. Alternative power supply = 7-20V DC.
❸RS-232 Serial Connector - Used for connecting Pan/Tilt/Zoom devices, etc.
❹RJ45 Network Connector - Variable data communication speed (10-100 Mbps).
❺Indicator LEDs - The Power LED shows steady green for normal operation, or flashing green or unlit for a malfunction in the
power supply. It will also flash amber during a firmware upgrade. The Status LED shows steady green for normal operation, or red
for critical errors. The Network LED flashes amber for 10Mbps network activity, flashes green for 100Mbps network activity, or
shows solid red for no network connection. An unlit indicator denotes no activity.
❻I/O Terminal Block B - Provides the physical interfaces to RS-485 Pan Tilt devices and 2 digital inputs. See page 46 for pinout
information.