Filter
Top Products
space-efficient design, 3) a variation of Code 128 that supports concatenation of neighboring
symbols, and 4) the standard layout for bar codes on a blood product label. Use the bar codes below
to turn concatenation on or off. Default=Off.
3.12.2 Code 128 Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description
(chapt 3.2) for additional information. Minimum and Maximum lengths = 0-80. Minimum Default = 0,
Maximum Default = 80.
Maximum Messa
g
e Len
g
th
3.12.3 Code 128 Code Page
Code pages define the mapping of character codes to characters. If the data received does not
display with the proper characters, it may be because the bar code being scanned was created using
a code page that is different from the one the host program is expecting. If this is the case, scan the
bar code below, select the code page with which the bar codes were created (see Code Page
Mapping of Printed Bar Codes on page A-6), and scan the value and the Save bar code from the
Programming Chart on the inside the back cover of this manual. The data characters should then
appear properly. Default = 2.
3.13 Telepen
3.13.1 Telepen Output
Using AIM Telepen Output, the imager reads symbols with start/stop pattern 1 and decodes them as
standard full ASCII (start/stop pattern 1). When Original Telepen Output is selected, the imager
reads symbols with start/stop pattern 1 and decodes them as compressed numeric with optional full
ASCII (start/stop pattern 2). Default = AIM Telepen Output.
23
Telepen
<Default All Telepen Settings>
Telepen
On
* Off
Code 128 Code Page