Filter
Top Products
2.5 Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 – 3 (maximum 3). The same number of
beeps will be applied to the beeper and LED in response to a good read. For example, if you program
this option to have two beeps, there will be two beeps and two LED flashes in response to a good
read. The beeps and LED flashes are in sync with one another. To change the number of beeps, scan
the bar code below and then scan a digit (1-3) bar code and the
Save
bar code on the Programming
Chart (Appendix E of this manual).
Default = One.
2.6 Good Read Delay
This sets the minimum amount of time before the imager can read another bar code.
Default = No Delay.
2.7 Aimer Delay
The aimer delay allows a delay time for the operator to aim the imager before the picture is taken. Use
these codes to set the time between when the trigger is activated and when the picture is taken.
During the delay time, the aiming light will appear, but the LEDs won’t turn on until the delay time is
over
6
* Normal Beep
Short Beep
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
400 milliseconds
* Off
(no delay)
200 milliseconds