Filter
Top Products
Source Connections
6-6 5975198 RETRODATA 808s 210397
Connecting external loudspeakers to the
retroprojector.
Connecting speakers wires.
Peel back the vinyl covering and twist the wire core.
Push with your finger on the black lever of the R(right) speaker input
and connect the speaker's minus (-) wire to the terminal. Remove
your finger from the lever and gently pull the wire to confirm that it is
securely connected.
Push with your finger on the red lever of the R(right) speaker input and
connect the speaker's plus (+) wire to the terminal. Remove your
finger from the lever and gently pull the wire to confirm that it is
securely connected.
Repeat the same procedure for the left speaker.
Precautions regarding connections :
* Be sure that no speaker wire protrudes and contacts other than its
own terminal.
* Be sure to correctly connect the right and left speakers, and the +
and - polarities. If the polarities of one of the speakers are connected
improperly, the right and left speakers will operate in reverse phase,
and the sense of stereo sound will be lost.
Speaker selection switch
To switch between internal loudspeakers or external loudspeakers.
When pressed : set for operation with sound output from the built-in
speaker system.
When not pressed : set for operation with sound output from the
external connected speakers.
PERIPHERAL EQUIPMENT
Connecting a RCVDS 05 switcher to the
retroprojector.
- Up to 20 inputs with the RCVDS 05 switcher and up to 90 inputs
when 10 RCVDS switchers are linked via the expansion modules.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the
retroprojector (source selection and analog settings)
- The selected source number will be displayed on a 2 digit display
and the selected input modules will be indicated with a LED on the
rear.
Order number : R9827880 (230V), R9827889 (120V)
For more information consult the Owner's Manual of the RCVDS.
Order number : R5975765
Connecting a VS05 switcher to the retroprojector.
The VS05 can switch up to 5 Composite Video sources, 3 S-Video
Sources and 1 RGB analog or component Video source to the
retroprojector. In addition, an audio signal associated with the
source, can be switched to an audio amplifier.
Order number : R9827890.
For more information consult the Owner's Manual, order number :
R5975245.
Connecting an IR Remote Receiver to the
retroprojector.
This infra-red receiver unit makes it possible to control the retroprojector
from another room. There is a communication line cable between the
IR receiver and the projector or the RCVDS 05. The infrared control
information from the Remote Control Unit is sent to the IR Remote
Receiver. The IR Remote Receiver 800 displays the selected source
on a 7-segment display.
Order number : R9827515.
10 mm
EXTERNAL
INTERNAL
L
R
R
L
RL
L
R