81
TROUBLESHOOTING
My connection type is
“static IP address”. I cannot
connect to the Internet.
My connection type is
“dynamic IP address”. I
cannot connect to the
Internet.
1. Since your connection type is “static IP
address”, your ISP must assign you the IP
address, subnet mask, and gateway address.
Make sure that the Router’s connection type
is configured as “Static IP Address” and
verify your settings.
2. Your ISP may bind your connection to the
MAC address of your computer’s NIC. Clone
your MAC address.
1. Make sure your computers are correctly
configured and all network cables are
properly connected.
2. Make sure the cable or DSL line is properly
attached on your cable or DSL modem. Refer
to the manual of your modem to verify that
it works normally.
3. Make sure the network cable between the
modem and the barricade is well connected.
Power off the modem; wait a few seconds
and then power it on again.
4. Your ISP may bind your connection to the
MAC address of your computer’s NIC. Clone
your MAC address.
80
The Easy Install Wizard is
not able to find my Router.
The WAN link LED is not on
or I cannot connect to the
cable or DSL modem.
TROUBLESHOOTING
1. Make sure that the Router is ON. The
Power/Ready light will be on GREEN and
SOLID. Check the power supply connection at
the wall and the Router.
2. Make sure that the LAN link light that
corresponds to the port you connected to
the computer is ON. Check the network cable
going from the computer to the Router.
3. If the Easy Install Wizard told you that it
detected multiple network adapters, run the
Easy Install Wizard again and try a different
adapter.
1. Check the connection between the Router
and the cable or DSL modem. Make sure the
network cable from the cable or DSL modem
is connected to the port on the Router
labeled “Internet/WAN”.
2. Make sure the cable or DSL modem is
powered and switched on.
3. Make sure the Router has power. The
Power/Ready LED should be illuminated.
4. Make sure the cable between the modem and
the Router is the cable that was provided
with the modem.