Filter
Top Products
Operation 25
If you forget the password
You will be asked to enter the four digit
password every time you turn on the projector.
If you enter the wrong password, the password
error message displays. You can retry by pressing
Up 5, or if you did not record the password in
this manual, and you absolutely do not
remember it, you can use the password recall
procedure.
Entering the password recall procedure
Press and hold Right4on the projector for 3 seconds. The projector will display 4 sets of
coded number on the screen. Write down the number and turn off your projector. Seek help
from the local BenQ service center to decode the number. You may be required to provide
proof of purchase documentation to verify that you are an authorized user of the projector.
Changing the password
1. Open the on-screen menu and go to Setting > Change Password.
2. Press Left 3or Right4.
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
ii. If the password is incorrect, a “Password Error” message displays. Press Up 5 to
try again or press Down 6 to cancel.
4Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it
is available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
5. Perform one of the following 3 steps.
i. Press Auto to confirm.
ii. Press Up 5 to try again.
iii. Press Down 6 to cancel the set-up and return to the on-screen menu.
6 Confirm the new password by re-entering the new password.
7. Perform one of the following 3 steps.
i. Pressing Auto completes the procedure.
ii. Press Up 5 to try again.
iii. Press Down 6 to cancel the set-up and return to the on-screen menu.
Password Error
Try again
Forgot password, please refer to User's manual