Filter
Top Products
Operation38
• Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use / to select a suitable time frame.
• Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use / to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD
menus. Use / to select your language.
• Reminder Messge in the SYSTEM SETUP: Basic >Menu Settings menu sets whether to
display reminder messages on screen. Use / to select your desired setting.
Shutting down the projector
1. Press Power and a confirmation message
displays prompting you. If you don't respond
in a few seconds, the message will disappear.If
you use the remote control, press OFF to shut
down the projector.
2. Press Power a second time. The POWER
indicator light flashes red, the projection lamp
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
• To protect the lamp, the projector will not respond
to any commands during the cooling process.
3. Once the cooling process finishes, the POWER indicator light is a steady red and fans
stop.
4. Disconnect the power cord from the power putlet if the projector will not be used in
an extended period of time.
• If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
• Actual lamp life may vary due to different environmental conditions and usage.
I
I
I
I