Filter
Top Products
Bizfon Manual I: Installation Guide Appendix: PC DHCP Settings
Appendix: PC DHCP Settings
The Bizfon LAN port has a DHCP server that provides DHCP IP addresses to devices con-
nected to the LAN either directly or through an Ethernet hub or switch. This appendix de-
scribes how to configure Windows PCs for DHCP. The PC used to access the Bizfon must
meet the following conditions:
• TCP/IP network protocol has to be installed.
.
• DHCP has to be activated in order to request the IP address automatically
Please Note: If your PC is already configured for DHCP and connected directly to the
Bizfon, then simply power it on and verify the LAN LED is lit. If LED is off, check the cable
connections.
Follow the instructions below to install TCP/IP and enable DHCP functionality:
TCP/IP and DHCP under Windows 2000/XP
Windows 2000 and Windows XP PCs with Ethernet cards or adapters normally are config-
ured with a TCP/IP network connection by default. Nothing in addition is required. To en-
able the DHCPs functionality, you may have to modify the properties of TCP/IP:
1. Click the Start button. Choose Settings, then
Control Panel.
2. Double-click on the Network Connection icon
to open the corresponding window. Select Lo-
cal Area Connection with the right mouse
button and select Properties.
3. Highlight Internet Protocol (TCP/IP) under
General tab and click Properties. The cor-
responding window will be displayed.
Bizfon2000 and Bizfon4000 (SW Version 3.1.x) 34