Filter
Top Products
Page 146
724-746-5500 | blackbox.com
Chapter 5: Operation
Example: Switching to favorite CPU 3 in Private Mode
<left Shift>, <left Shift>, <3>, <left Shift>, <Enter>
Direct Switching of Video
1. Start Command Mode with the hotkey. For control, the LEDs Shift and Scroll
flashes at the keyboard, if command mode is activated.
2. Enter the index number of the new CPU from the list of favorites and confirm
with <Space>.
At the same time, the Command Mode is closed and the console is connected to
the new CPU with video only.
NOTE: You can only use the hotkeys to switch to unused and allowed CPUs.
Hotkeys are only supported if neither “Enable User Login” nor “Enable User
ACL” is selected and the user is logged in the OSD.
Switch to previous CPU
1. Start Command Mode using hotkeys. For control, the Shift and Scroll LEDs on
the keyboard flash when Command Mode is activated.
2. Press the <p> key on your keyboard. The Command Mode closes, and the
console connects to the previous CPU with complete control.
NOTES:
If you switch to a previous CPU that was connected with Video Access before,
you will be connected to this CPU with full KVM access.
You can only switch to unused and allowed CPUs with hotkeys. The “Force
Connect” and “Force Disconnect” options, as well as the restrictions of the User
ACL and CON ACL, are taken into account. Hotkeys are only supported if neither
Enable User Login nor the Enable User ACL is selected and the user is logged in
the OSD.
5.1.2 Scan Mode
The Scan Mode can show video signals of the different CPUs fast and without
delay and switch continuously using the hotkey. Switching between two video
signals can even take place within one frame.