Filter
Top Products
ET1000A Physical Description
ETEP Installation Guide 17
Figure 9 ET1000A LED Indicators
Table 3 describes how to interpret the LEDs on the ET1000A front panel.
Elements of Figure 9:
1) Power LED
2) Alarm LED
3) Diagnostic display
4) Link indicators: 10/100 Ethernet management port
5) Link indicators: Gigabit management port
6) Link indicators: Aux1, Remote and Local ports
7) Power supply status LEDs
Table 3 ET1000A Front Panel LED Indicators
Indicator Light State Indication
Power (green) Off Unit is powered off.
On Unit is powered on.
Alarm (green) Off Normal operation.
On The unit is in an error state. This occurs when the
diagnostics detect a boot failure, a critical error threshold is
exceeded, or a FIPS test fails.
Diagnostic code display On Displays diagnostic codes during boot up. After boot up, it
reflects the operational state of the appliance and error
conditions.
10/100 link status (green) Off Loss of signal on the 10/100 link.
On The 10/100 link is up but no traffic is passing over the link.
Blinking Indicates the presence of traffic on the 10/100 link.
Gigabit link status (green)
a
a. Gigabit links include the remote and local data ports, gigabit Ethernet management port, and Aux1 port.
Off Loss of signal on the Gigabit link.
On The Gigabit link is up but no traffic is passing over the link.
Blinking Indicates the presence of traffic on the Gigabit link.
Power supply status Off Power supply is not operational. Possible causes include
power supply unplugged, power supply removed from
chassis, or a malfunction.
On Power supply is operational.