Filter
Top Products
Setting the Date and Time
ETEP Installation Guide 51
Example
The following example sets the management port IPv4 address, subnet mask, and gateway for the
ETEP as shown in Figure 34. Auto-negotiation is left at its default setting of enabled.
admin> configure
config> management-interface
man-if> ip 192.168.10.10 255.255.255.0 192.168.10.1
man-if> exit
The next example sets the management IPv4 address and subnet mask, and omits the default gateway.
The default gateway can be omitted when the management station and the ETEP management port
and are wired directly to each other on the same subnet. Auto-negotiation is disabled. The link speed
is set to 100 Mbps full-duplex and flow control is turned on.
admin> configure
config> management-interface
man-if> ip 192.168.10.10 255.255.255.255
man-if> autoneg disable 100m-full on
man-if> exit
The following example sets an IPv6 address, prefix length, and default gateway on the management
port.
admin> configure
config> management-interface
man-if> ip6 2001:DB8::211:11FF:FE58:743/64 2001:DB8::20F:F7FF:FE84:BFC2
man-if> exit
config>
Setting the Date and Time
Setting the date and time on the ETEP helps ensure that the appliance’s time can be synchronized
properly with other ETEPs or components in the EncrypTight system.
The time zone on the ETEP is set to UTC 0 (Coordinated Universal Time), and is not user configurable.
Enter the date and time relative to UTC 0, also referred to as Greenwich Mean Time (GMT). To calculate
Table 19 Management port autoneg command description
Attribute Description
enable Enables auto-negotiation on the management port. This is the default
setting.
disable Disables auto-negotiation on the management port. Use this setting to
manually configure link speed and flow control.
speed [100m-full | 10m-full | 100m-half | 10m-half]
When auto-negotiation is disabled, the speed attribute specifies the link
speed and duplex setting. The speed defaults to 100m-full.
flow control [on | off]
When auto-negotiation is disabled, this attribute configures the flow control
setting to be on or off. The flow control setting defaults to on.