Filter
Top Products
Installation
38 ETEP Installation Guide
Figure 23 ET0100A Cabling
Powering on the ET0100A
Use the following procedure to power up the ET0100A.
To power on the ET0100A:
● On the appliance’s rear panel, plug the power cord into the ET0100A power receptacle. Attach the
opposite end to a power source to apply power to the appliance.
Due to the shielding in the power cable, you must exert significant pressure to properly insert the power
cord into the ET0100A power receptacle. A properly seated power cord cannot be moved within the
receptacle (Figure 24). Wiggling or jostling an improperly seated power cord may cause the appliance to
reboot (Figure 25).
Figure 24 Properly seated ET0100A power cable