Filter
Top Products
ETEP Installation Guide 47
3 Initial Setup
This section includes the following topics:
● Overview
● Logging In Through a Serial Link
● Configuring the Management Port
● Setting the Date and Time
● Entering a Throughput License
● Configuration Example
● Managing the ETEP
Overview
The following steps are required for initial setup of the ETEP:
1 Log in through a serial link.
2 Configure the management port.
3 Set the date and time.
4 Enter the throughput license.
Logging In Through a Serial Link
Initial setup is performed through a serial link to the RS-232 port. The initial setup commands are
available to the Admin and Ops users. The procedures and examples in this chapter assume that the
Admin user is performing the setup tasks.