Filter
Top Products
ServSwitch™ Wizard DP USB
724-746-5500 | blackbox.com
Page 20
4.2.4 OPTIONS port channel control behavior
You can determine how the OPTIONS port responds to channel control inputs.
4.2.4.1 To define the OPTIONS port behavior
1 Enter the Configuration menu.
2 Press to enter the Options port menu and then press either:
to allow channel switching commands to be received via RS-232 serial signal through the OPTIONS port. The baud rate cur-
rently set by the option will be used for the port. Switching commands via the four channel select inputs within the
OPTIONS port connector are disabled in this mode. Use option if you wish to enable the channel select inputs in addition to
RS-232 control.
to allow channel switching commands to be received from the optional remote control. The baud rate set by the option
is ignored and the rate used by the remote control is automatically imposed. Switching commands via the four channel select
inputs within the OPTIONS port connector are disabled in this mode.
enables channel switching via RS-232 as per option . However, in this mode the four channel select inputs are also
enabled.
3 Press to accept the setting and return to the main menu section.
4 Press and then to exit the menu and save changes.
4.2.5 Switching mode
Using the configuration menu, you can define a default switching mode. The switching mode determines which peripherals
(KVM, USB1, USB2 and/or speakers) should be moved to the next computer when it is selected using any of the standard meth-
ods. Regardless of the default switching mode set here, during use you can always change the mode using either the MODE but-
ton (on the front panel) or using the additional hotkey press combinations.
Note: Of the external switching methods, the optional remote control and the RS-232 serial signal inputs will switch the peripher-
als as defined by the currently selected switching mode. However, switching control initiated by the channel select input lines will
always switch all of the peripherals to the chosen channel regardless of the switching mode.
4.2.5.1 To set the default switching mode
1 Enter the Configuration menu.
2 Press to enter the Switch Mode menu and then press either:
to select All
(default)
to select KVM and speaker
to select KVM only
to select Speaker only
to select USB1 only
to select USB2 only
3 Press to accept the setting and return to the main menu section.
4 Press and then to exit the menu and save changes.