Black Box LB510A-R2 Switch User Manual


 
724-746-5500 | blackbox.com
Page 30
Black Box G.SHDSL.bis EFM CPE
Figure 10.
Remote control session diagram
5.1 ESTABLISHING A REMOTE CONSOLE SESSION
5.1.1 How to Connect
The following steps are to establish a connection to the remote LB510A-R2 (far-end)
via Remote Console Session (RCS):
1. Connect to the console port of the LB510A-R2 (near-end) via Telnet session.
2. At the password prompt, log in to the near-end LB510A-R2.
3. Ensure that a DSL link is established. You can verify an established DSL link by
us
ing the system show status command or by checking that the DSL LED is solid
green. Upon executing the show status command, the dsl link state is shown as
success if the DSL link is established.
4. At the command prompt, enter the command re
mote console.
5. Wait for the message C
onsole: Remote console connection established.
-If a DSL link is not established, or for some other reason the LB510A-R2 (far-
e
nd) does not respond in a reasonable amount of time, the following message
appears: Console: Remote console timed out trying to connect. Enter the com-
mand remote console again.
-If LB510A-R2 (Far End) already has an active remote console session open, you
w
ill see the message Console: Remote console connection request rejected. This
can also happen if the remote LB510A-R2 (far-end) has an established remote
console session with the local LB510A-R2 (near-end) which has timed out.
6. Enter the password at the password prompt for the remote console session.