Filter
Top Products
20
Modem 34336
Autodialing the Stored Number. To autodial the stored number from
the EIA status screen, press the following pushbuttons in sequence:
ENT
Pushbutton 3 (to select DIAL from MAIN MENU screen 1)
Pushbutton 1 (to select DIAL from the AUTO-DIAL screen)
When the local modem successfully establishes a connection with the remote
unit, the EIA status screen should be present. This screen looks like the one
shown below.
If the modem’s LCD displays an AUTO-DIAL FAILURE message,
refer to Table 2-2.
Terminating a Data Call. Normal termination of a data call is processed
through communication software. An alternate method is switching the
HANGUP option on the AUTO-DIAL screen. Another method is to drop
the DTR signal from the DTE (by software control or by turning the DTE off).
For manual originate/answer operation, see Chapter 4.
2.4.4 L
EASED
L
INE
(2-
OR
4-W
IRE
) M
ODE
(Q
UICK
S
ETUPS
6, 7, 8,
AND
9)
This section does not apply to V.33 leased line operation. For V.33 leased line
operation, see the next section.
Table 2-2. Auto-Dial Failure Messages.
FAILURE MESSAGE EXPLANATION
LINE OCCUPIED The data line is already in use.
DIAL NOT ALLOWED Modem is not configured for dial
backup.
NO DTR DTR is not present.
NO LINE CURR Loss of line current.
D TR MR RS CS TD
9600 CD RD
12
3