Filter
Top Products
73
4.0 General Operation and Special Features
A carriage return [CR] is required at the end of a command line except
when the command line consists of only one single-character command.
Commands can be entered in upper or lower case.
Other diagnostic port commands are available for factory use only.
Therefore, some commands that are not listed above may produce
a response.
When an address is specified with the CONNECT or CON command,
leading zeros are ignored, meaning that any of the following forms will work:
CONNECT 3,22
CONNECT 003,022
CON 000003,22
If a group or unit address is not specified, it is assumed to be zero:
CONNECT, 3 (same as CONNECT 0,3). Note that a comma is required,
even if no group or unit number is used.
4.9.3 R
ESPONSES TO
D
IAGNOSTIC
P
ORT
C
OMMANDS
In response to the diagnostic port commands listed in Table 3-3, the
Modem may display the responses listed in Table 4-4 on the DTE monitor.