Filter
Top Products
98
Modem 34336
Table 5-1 (continued). Hayes Compatible Commands.
COMMAND FUNCTION/EXPLANATION
S= Modify S Register
Parameters are register and value to be written.
S? Read S Register
Parameter is the register number.
T Tone Dialing
No parameters.
V Word/Digit Result Code
V0 Result codes are transmitted as digits.
V1 Result codes are transmitted as words.
W Wait For Dial Tone
No parameters, but default wait time (register S7) is
30 seconds.
X Select Result Code
X0 Selects basic result codes, 0-4. No speed indication;
no busy or dial tone detect.
X1 Selects result codes 0-5, 10, 11, 13, 14, 15, and 18.
Connection speed (up to 14,400 bps) indicated; no
busy or dial tone detect.
X2 Selects result codes 0-6, 10, 11, 13, 14, 15, and 18.
Same as X1 except dial tone detect is enabled.
X3 Selects result codes 0-5, 7, 10, 11, 13, 14, 15, and 18.
Same as X1 except busy-signal detect is enabled.
X4 Selects all result codes. Connection speed (up to
14,400 bps) indicated; busy-signal and dial-tone detect
enabled.
Note: Result code 8 is independent of the X command;
it is displayed only when the @ dial modifier is used.
Default settings (where applicable) are in bold face.
* If user profile 1 is active, options are controlled (for Hayes mode
operation) by given commands or Summary Setup. Do not change via
front panel (except via Summary Setup).