Filter
Top Products
SPECIAL HEAD?
Is used when a special paper path size is installed (2.125”, 2.5”, 2.7”...)
Here are the following choices:
PATH TYPE?
Defines the number of paper paths used.
Here are the following choices:
BUFFER MODE?
Defines when the printer will go busy.
Here are the following choices:
CLEAR DOWNLOAD?
Clears those items downloaded by the operator (PCX or softfonts).
Your choices are YES or NO.
DEFAULT SETTING
Resets the printer back to the factory default setting.
Your choices are YES or NO.
INC CUT1 COUNT?
Enables the operator to move the cut or tear position to the left (towards the ticket
entrance area). Cut counts are increments of .003” for 300dpi and .002” for 200dpi.
The count value is changed by depressing CHOICES.
16 is factory default.
DEC CUT1 COUNT?
Enables the operator to move the cut or tear position to the right (towards the ticket exit
area). Cut counts are decrements of .003” for 300dpi and .002” for 200dpi. The count
value is changed by depressing CHOICES. 16 is factory default.
12
NO NO special head (factory default)
O
N P1 SINGLE PATH PRINTER ONLY. DUAL PATH PRINTER PATH #1
ON P2 DUAL PATH PRINTER PATH #2
ON BOTH DUAL PATH PRINTER BOTH PATHS
REV ADJ2 P1 DUAL & SINGLE PATH PRINTER WITH REV ADJ2 PATH ONLY
REV ADJ2 P2 DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY
R
EV ADJ BOTH DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY
PATH 1 Locks a Dual path printer onto path#1 (all single path printers) (factory default)
PATH 2 Locks a Dual path printer onto path #2
DUAL Is used for Dual path printer
DUAL SUPPLY Please consult your programming Guide (Dual Printer Supplement)
VENTEK DUAL Special settings only used by certain customers.
SINGLE MODE 1 Go busy after each print command inserted in buffer
SINGLE MODE 2 Go busy after receiving <p> command
MULTIPLE MODE Go busy when the input buffer is full (~4k) (factory default)