Filter
Top Products
8.1.5.5 Ticket Load Switch
The ticket load switch should be positioned such that the printer automatically activates
the stepper motor at the proper time when tickets are loaded into the printer. When
loading tickets, the stepper motor should turn on when the ticket stops in front of the
thermal head. At this point, the ticket will be grabbed out of your hand and fed into the
printer. If the motor does not activate, make sure the ticket stock is loaded into the
printer properly.
22
F
EED DIRECTION
Figure 8 - Optical Device
O
ptical Device, Ticket Cut
P
aper Guide
Grn/Red/Blk
Wires
5
/
64
”
Allen Head
Screws
On some models these
c
onnectors plug into the
back of the circuit board
TO LOGIC
BOARD
Figure 8a - Ticket Load Switch
(Print Head removed)