Filter
Top Products
Follow the instructions described in Roll Media.
The Rewind Option must be installed in the printer. To initially
configure the printer for this mode, follow these steps:
1. Remove the Media Rewind Plate from its storage location in
front of the printhead inside the media compartment.
2. Invert the Rewind Plate so that the lip on the attached Hook
Plate points down.
3. Insert the Hook Plate lip a short distance (1/2") into the lower
opening in the Side Plate.
4. Align the upper end of the Rewind Plate with the correspond-
ing opening in the Side Plate and slide the Rewind Plate in so
that it stops against the Main Frame.
5. Remove the Hook from the Take-Up Spindle Shaft.
6. Route the media as shown in Figures 2.4 and 2.5, wind it 1-2
times around a 3" core.
After loading the media, follow these steps:
1. Remove the Rewind Plate if one is present and store it on the
two mounting screws on the inside of the front panel. Align
the notch or web in the media so that the Take Label Sensor
can sense a peeled label.
2. Load media as shown in Figures 2.4 and 2.5.
3. Remove the Hook from the Take-Up Spindle Shaft.
4. Remove several labels from the media backing and then wind
the backing 1-2 times around the Media Take-Up Spindle and
reinstall the Hook.
2-9