Filter
Top Products
To remove used ribbon, refer to Figure 2.7 and follow the steps
below.
1. Pull the hook out slightly, then rotate the hook back-and-forth
several times as shown and remove it from the spindle.
2. Grasp the used rib-
bon and remove it
from the Ribbon
Take-Up Spindle.
3. Remove the
empty core from
the Ribbon Sup-
ply Spindle.
4. Follow the Rib-
bon Loading pro-
cedure on page
2-4 to load the
new ribbon.
After you finish loading the ribbon and media, continue reading
through Sections 3 and 4. Perform the following initial printer
power-up steps as you come to them:
1. Power ON Self Test (POST)
2. Calibration
Subsequent power-ups will not necessarily require step 2 to be
performed. See Sections 3 and 4 for further information.
2-11