Filter
Top Products
Setup 17
BASIC USE
Setting the Music on Hold
You can set the machine to play or not to play the music during the machine is holding a voice call.
1
Press Menu/Set, 1, 6.
2
Press or to select ON (or OFF), and press Menu/Set when the screen displays your
selection.
3
Press Stop/Exit.
Setting the Dialling Mode (Tone/Pulse)
Your machine is initially set to TONE. If you are using a PULSE dial line, you can change the
setting to PULSE by following the steps below.
1
Press Menu/Set, 1, 7. The screen prompts you to select TONE or PULSE.
2
Use or to select the dialling mode, and press Menu/Set when the screen displays the
dialling mode you want.
3
Press Stop/Exit.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements for
correct operation. It is therefore strongly recommended that the equipment is set
to use the Tone signalling for access to public or private emergency services. The
Tone signalling also provides faster call set up.