Filter
Top Products
4. Control Panel
52
Reprinting documents
Reprinting from RAM
You can reprint from random access memory (RAM). The reprint data in RAM will be deleted when the printer
is turned off.
When you use RAM to reprint:
a Press Set on the control panel.
b Press the + or - button to choose SETUP. Press Set.
c Press the + or - button to choose RAMDISK SIZE. Press Set.
d The present RAM disk is 0MB. Press the + button to increase the reprint RAM size in increments of 1MB.
e Press Set.
Note
When you increase the RAM size for secure printing, the work area of the printer is decreased and the
printer performance will be reduced. Make sure that you reset the RAM disk size to 0MB after you finish
using secure printing.
We recommend that you add more RAM if you want to be able to print a lot of secure data. (See Installing
extra memory on page 71).
Reprinting the last job
You can reprint the data from the last print job without sending it from the computer again.
Note
• If the REPRINT setting is set to OFF on the control panel and you press Reprint, the LCD shows
NO DATA STORED for a short time.
• If you want to cancel reprinting, press Job Cancel.
• If the printer does not have enough memory to spool the print job data, it will only print the last page.
• Pressing the - or + button makes the number of reprint copies decrease or increase. You can choose
between 1 and 999 COPIES.
• For more information about the settings in the printer driver, see Device Options on page 31.