Filter
Top Products
63
5
Drawing
Scanning
Not all of the material to
be cut is cut. Some
areas remain uncut.
An iron-on fabric appliqué contact
sheet is not firmly attached to a
fabric.
Iron the entire contact sheet to affix it
firmly to the wrong side of the fabric.
page 16
There are deep cuts
completely through the
mat.
The blade extension from the blade
holder is too much.
Remove the holder from the carriage, and
then adjust the blade extension.
page 18
The cutting pressure (“Cut
Pressure”) is incorrect.
Adjust the setting for “Cut Pressure” in the
settings screen.
page 18
page 23
Symptom Possible Causes (or Results) Solutions Reference
The drawn line is thicker
(thinner) than intended.
The drawing speed (“Draw Speed”)
or drawing pressure (“Draw
Pressure”) is incorrect.
Adjust the settings for “Draw Speed” and
“Draw Pressure” in the settings screen.
To draw thicker lines, increase the
drawing pressure. To draw thinner lines,
decrease the drawing pressure.
To draw thicker lines, reduce the drawing
speed. To draw thinner lines, increase the
drawing speed.
After adjusting the settings, perform a trial
drawing operation.
page 23
Symptom Possible Causes (or Results) Solutions Reference
Unwanted images are
scanned.
The scanning area is incorrectly
specified.
In “Scan to USB” mode, specify the paper
size with the “Scan Size” setting.
page 54
In “Direct Cut” or “Scan to Cut Data”
mode, trim the image in the editing screen
after scanning.
page 48
page 51
Scanning cannot be
done cleanly (there are
lines in the scanned
image).
The scanner glass is dirty.
Clean the scanner glass from the bottom
of the machine.
page 59
The original to be scanned is dirty or
scratched.
In “Scan to Cut Data” mode, remove thin
lines or dirt in the image editing screen.
page 52
The lines printed on the
mat are scanned.
The original is transparent so the
lines printed on the mat are being
scanned.
In “Scan to Cut Data” mode, remove the
lines in the image editing screen.
page 52
The scanned image is
red.
When the optional scanning mat is
used, scanning is performed without
peeling off the blue tape.
Peel off the blue tape from the optional
scanning mat before scanning.
—
Symptom Possible Causes (or Results) Solutions Reference