Filter
Top Products
66
Using a USB flash drive, the machine’s software can
be upgraded. For upgrade information, refer to
details posted on the Brother Solutions Center (http://
solutions.brother.com/). If an upgrade file is posted,
download the file, and then upgrade the machine
according to the following procedure.
a While holding down in the operation
panel, press to turn on the machine.
b Plug the USB flash drive containing the upgrade
file into the USB port on this machine.
The USB flash drive must not contain any data other
than the upgrade file. Otherwise, the machine may
stop operating correctly.
Note
• This machine is incompatible with a USB hub.
Plug the USB flash drive directly into the USB
port.
c Touch the “Update” key to start the upgrade.
X When upgrading is finished, the completion
message appears.
d Unplug the USB flash drive from the port.
e Turn the machine off, then on again.
The following are available as optional accessories
to be purchased separately.
* Contact the retailer who sold you this machine or
the nearest authorized service center.
UPGRADING THE SOFTWARE OPTIONAL ACCESSORIES
1. 2. 3.
4. 5. 6.
7. 8. 9.
10. 11. 12.
13. 14. 15.
No. Part Name Part Code
1
Low tack adhesive mat 12" × 12"
(305 mm × 305 mm) (turquoise)
CAMATP12
2
Low tack adhesive mat 12" × 24"
(305 mm × 610 mm) (turquoise)
CAMATP24
3
Standard cut blade holder
(turquoise) (with no blade)
CAHLP1
4 Standard cut blade CABLDP1
5
Scanning mat 12" × 12"
(305 mm × 305 mm)
CAMATS12
6
Standard mat 12" × 12"
(305 mm × 305 mm)
(turquoise and purple)
CAMATF12
7
Standard mat 12" × 24"
(305 mm × 610 mm)
(turquoise and purple)
CAMATF24
8
Deep cut blade holder (purple)
(with no blade)
CAHLF1
9 Deep cut blade CABLDF1
10 Pen holder CAPENHL1
11 Color pen set CAPEN1
12 Erasable pen set CAPEN2
13 Contents USB *
14
Iron-on fabric appliqué contact
sheet (white backing)
CASTBL1
15
High tack adhesive fabric support
sheet (light blue backing)
CASTBL2