Filter
Top Products
Chapter 2
14
Labels 2
The machine will print on most types of labels
designed for use with a laser machine. Labels
should have an adhesive that is acrylic-based
since this material is more stable at the high
temperatures in the fuser unit. Adhesives
should not come in contact with any part of
the machine, because the label stock may
stick to the belt unit or rollers and cause jams
and print quality problems. No adhesive
should be exposed between the labels.
Labels should be arranged so that they cover
the entire length and width of the sheet. Using
labels with spaces may result in labels
peeling off and causing serious jams or print
problems.
All labels used in this machine must be able
to withstand a temperature of 392 degrees
Fahrenheit (200 degrees centigrade) for a
period of 0.1 seconds.
Label sheets should not exceed the paper
weight specifications described in this User’s
Guide. Labels exceeding this specification
may not feed or print properly and may cause
damage to your machine.
Labels can be fed from the MP tray only.
Types of labels to avoid 2
Do not use labels that are damaged, curled,
wrinkled or an unusual shape.
CAUTION
Avoid feeding labels with the carrier sheet
exposed because your machine will be
damaged.
Unprintable area 2
Unprintable area for copies 2
The printable area of your machine begins at
approximately 0.16 in. (4 mm) from the top
and bottom and 0.12 in. (3 mm) from both
sides of the paper.
1 0.16 in. (4 mm)
2 0.12 in. (3 mm)
Note
This unprintable area shown above is for a
single copy or a 1 in 1 copy using Letter
size paper. The unprintable area changes
with the paper size.
2
2
1
1