Brother PJ-522 Printer User Manual


 
Page 37
4. Grasp the battery removal ribbon, which is attached to the inside of the battery
compartment. See Figure 12.
NOTE: If you forget to hold on to the ribbon, you may accidentally insert the
battery on top of it. Then you won’t be able to remove the battery by pulling
the ribbon.
Figure 12. Placing the battery inside the
battery compartment
5. While holding onto the ribbon, tilt the battery and place it inside the battery
compartment. Once the battery clears the outer edges of the compartment, press it
securely into position.
Make sure the label faces the outside of the battery compartment. Otherwise, the
battery cover will not close properly.
NOTE: The side of the battery opposite the warning label contains a heat sensor
that stops the ow of electricity if the battery overheats.
6. Attach the battery cover rst to the end of the battery compartment opposite the AC
adapter receptacle. Close and latch the cover. If necessary, gently push the cover
latch towards the AC adapter receptacle until it latches.