Filter
Top Products
Workgroup Remote Access Switch 103
A
PPLE
T
ALK
R
OUTING
N
ETWORK
Configure the CyberSWITCH
CONFIGURING DEVICE SITE2’S AUTHENTICATION INFORMATION
At the Device Table Menu, select Authentication. You may then enter the authentication information
needed for this device. The information needed for each device depends on the device type.
For device SITE2, because we will be configuring CHAP security, we will configure a CHAP secret
(ikcd98s). After the secret has been entered, the Device Authentication Menu will appear as follows:
Again, return to the Device Table Menu.
C
ONFIGURING DEVICE SITE2’S APPLETALK INFORMATION
To begin the configuration of device SITE2’s AppleTalk information, select AppleTalk from the
Device Table menu. A menu will then be displayed with preconfigured default values. as shown
below:
To complete the AppleTalk configuration for device SITE2:
• Select AppleTalk Address. Because this device is over an unnumbered link, enter 0.0 for the Ap-
pleTalk address.
• Select AppleTalk Routing. Follow the on-screen instructions to enable AppleTalk routing for
SITE2.
• Select Make calls for AppleTalk Data. Follow the on-screen instructions to enable making calls for
AppleTalk data.
Device Authentication Menu: (Device = "SITE2")
PPP:
1) PAP Password ""
2) CHAP Secret "ikcd98s"
3) Outbound Authentication ENABLED
4) User Level Authentication DISABLED
IP Host (RFC 1294):
5) IP Host Id ""
HDLC Bridge:
6) Bridge Ethernet Address ""
7) Bridge Password ""
ISDN:
8) Calling Line Id(s) ""
Select function from above or <RET> for previous menu:
Device AppleTalk Menu: (Device = "SITE2")
1) AppleTalk Address None
2) AppleTalk Routing DISABLED
3) Make calls for AppleTalk data DISABLED
4) AppleTalk Routing Protocol None
Select function from above or <RET> for previous menu: