Filter
Top Products
Workgroup Remote Access Switch 91
IPX R
OUTING
N
ETWORK
Configure IPX Routing: Masternet (Detroit)
IPX STATIC ROUTES
Assuming the router at Dallas supports triggered RIP over the WAN, it is not necessary to
configure static routes. For our example, we will skip this configurable option.
If dallasnet did not support triggered RIP, you would then need to configure the appropriate static
routes. You would follow the on-screen prompts, remembering that routes to both internal and
external networks must usually be configured.
C
ONFIGURE NETWARE STATIC SERVICES
Assuming the router at Dallas supports triggered SAP over the WAN, it is not necessary to
configure static services. For our example, we will skip this configurable option.
Similarly, configure static services if dallasnet did not support triggered SAP.
R
OUTING PROTOCOLS
To allow the sending of triggered RIP/SAP traffic back and forth to the Dallas site, we need to
enable the RIP/SAP routing protocols. From the IPX Menu, select Routing Protocols (Enable/Disable).
Based upon the display, insure that both RIP processing and SAP processing are enabled. Follow
the on-screen instructions to make any necessary changes.
Note that you may also specify the size of table entries. For our example, we will skip this
configuration since we will accept the default values for these options.
IPX S
POOFING
To avoid excessive ISDN connections, the CyberSWITCH uses spoofing and automatic filtering
techniques. Both IPX and SPX Watchdog spoofing are enabled by default. For purposes of our
example, we will keep these default settings.
T
YPE 20 PROTOCOL
This option pertains to certain protocol implementations such as NetBIOS. Since this
implementation is not applicable to our example, we will leave this feature disabled.
I
SOLATED MODE
Since this implementation is not applicable to our example, we will leave this feature disabled.
T
RIGGERED RIP/SAP
From the IPX menu, select IPX Triggered RIP/SAP. From the resulting screen, you may display
WAN peer list information, or change the global RIP/SAP timer configuration. View the WAN
peer list to assure that dallasnet is properly listed. Skip past the global timer configuration, since we
will accept the default values for this option.