Filter
Top Products
Workgroup Remote Access Switch 15
S
IMPLE
R
EMOTE
B
RIDGING
N
ETWORK
Bridging and Routing Information
To configure the IP host interface:
1. Select IP Interfaces from the IP configuration menu.
2. Select to add an interface.
3. Enter the IP address assigned to this interface. For SITE1, this is 192.42.1.6; for SITE2, this is
192.42.1.7.
4. Enter the subnet mask.
5. Enter the MTU size.
6. Select the transmit broadcast address.
If IP RIP is enabled, enter the following additional information:
7. IP RIP receive control.
8. IP RIP respond control.
9. IP RIP v2 authentication control.
10. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has been
configured with a value other than “No Authentication.“
For more detailed information on the IP host operating mode, refer to the IP Operating Mode section
in the Configuring Basic IP Routing chapter of the User’s Guide.
C
ONFIGURING THE SECURITY
For this network configuration, we require no security. The default configuration is device security
enabled. To make the required configuration change, select Security from the Main Menu. Then
select Security Level. Finally, select No Security.
SAVE CONFIGURATION FILES
We have now configured all of the required information. Press 4 from the Main menu to save the
changes and then press <RET> to exit. Reboot the system to activate your changes.