Cabletron Systems 2E48-27R Switch User Manual


 
General Configuration Screen
2E48-27R/2E49-27R User’s Guide 5-23
5.7.3 Setting the Default Gateway
If the SNMP management station is located on a different IP subnet than
the 2E4X-27R, a default gateway must be specified. When an SNMP Trap
is generated, the 2E4X-27R sends the Trap to the default gateway. To set
the default gateway, perform the following steps:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the IP address of the default gateway using the DDN format.
For example: 134.141.79.121
3. Press ENTER. If the default gateway entered is a valid format, the
cursor returns to the beginning of the Default Gateway field. If the
entry is not valid, the screen displays “INVALID DEFAULT
GATEWAY OR FORMAT ENTERED”. Local Management does not
alter the current value, but it does refresh the Default Gateway field
with the previous value.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The message “SAVED OK” displays at the top of the
screen.
5.7.4 Setting the TFTP Gateway IP Address
If the network TFTP server is located on a different IP subnet than the
2E4X-27R, a Gateway IP address should be specified. To set the TFTP
Gateway IP address, perform the following steps:
1. Use the arrow keys to highlight the TFTP Gateway IP Addr field.
2. Enter the IP address of the TFTP gateway using the DDN format.
For example: 134.141.80.122
3. Press ENTER. If the TFTP gateway IP address entered is a valid
format, the cursor returns to the beginning of the TFTP Gateway IP
Address field. If the entry is not valid, the screen displays “INVALID
TFTP GATEWAY IP ADDRESS OR FORMAT ENTERED”. Local
Management does not alter the current value, but it does refresh the
TFTP Gateway IP Address field with the previous value.
4. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in Figure 5-12 displays.