Cabletron Systems 2E48-27R Switch User Manual


 
Chapter 5: Local Management
5-50 2E48-27R/2E49-27R User’s Guide
The following briefly explains each screen accessible from the High
Speed Interface Configuration Menu screen.
FAST ETHERNET INTERFACES
Displays a screen named High Speed Interface Configuration. This screen
shows the types of Fast Ethernet Interface Modules installed in ports 25
and 26, their current operating mode, and indicates if the ports are linked.
This screen also allows the user to enable or disable Auto-Negotiation and
set the Advertised Ability. For details, refer to Section 5.15.
HSIM
Displays the types of interfaces installed in the High Speed Interface
Module (HSIM) slots. The HSIM screens are described in their respective
user’s guides.
5.15 HIGH SPEED INTERFACE CONFIGURATION
SCREEN
The High Speed Interface Configuration screen displays the types of
interfaces installed in ports 25 and 26, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
To access the High Speed Interface Configuration screen from the High
Speed Interface Configuration Menu screen, use the arrow keys to
highlight the FAST ETHERNET INTERFACES menu item and press
ENTER. The High Speed Interface Configuration screen displays.
NOTE
The High Speed Interface Configuration screen, Figure 5-23,
applies only to ports 25 and 26. This screen supports the
FE-100TX, FE-100FX, and FE-100F3 Fast Ethernet Interface
Modules that operate at 100 Mbps.