Filter
Top Products
Using the EMM-E6 Hub View
2-28 Managing the Hub
Figure 2-14. EMM-E6 Polling Intervals
3. To activate the desired polling, click mouse button 1 on the selection box to
the right of each polling type field.
4. To change a polling interval, highlight the value you would like to change, and
enter a new value in seconds. Note that the Use Defaults option must
not
be
selected, or values will revert back to default levels when you click on
, and your changes will be ignored.
5. If you wish to use your new polling interval settings as the default values that
SPMA will use for each EMM-E6 you are managing, use mouse button 1 to
select the Save As Defaults option.
6. If you wish to replace existing values with the current set of default values, use
mouse button 1 to select the Use Defaults option.
7. Click mouse button 1 on once your changes are complete.
Changes take effect after the current polling cycle is complete.
You can set the update intervals for the following:
Contact Status
This polling interval controls how often the EMM-E6 is “pinged” to check SPMA’s
ability to maintain a connection with the device.
Device General Status
This polling interval controls how often the Hub View Front Panel Information —
such as Uptime, Device Name, and so forth — and some network, module, and
port status information is updated.