Filter
Top Products
Source Addressing
6-8 Configuring Source Address Traps
Other traps that will be sent in response to changes in source addressing (even
when the above traps have been disabled) include:
• PortTypeChanged traps are issued when a port’s topology status changes
from station to trunk, or vice versa. The interesting information includes the
board and port index, and the port’s new topology status.
•A lockStatusChanged trap is generated when the ports in the hub are locked
or unlocked using the Source Address Lock option in the Source Address List
window or by using the lock options in the Security application; the interesting
information is the new lock status. (See Locking Source Addresses,page 6-5,
or Chapter 7, Security, for more information.)
• PortSecurityViolation and portViolationReset traps are sent in response to
changes related to port locking: if ports are locked, the portSecurityViolation
trap indicates that a new source address has attempted access on one of the
ports, and the configured security actions are being taken; the interesting
information is the board and port index, and the violating address.
PortViolationReset traps are sent when management intervention has re-
enabled a port or ports previously disabled in response to a port security
violation; the interesting information is board and port index. Again, see
Locking Source Addresses,page 6-5, for more information.
Repeater-level Traps
The current status of the repeater-level source addressing traps is displayed in the
Source Address Traps field in the Source Address List window (Figure 6-2,
page 6-3).
A status of Enabled indicates that source address traps have been enabled for all
ports on all modules installed in the EMM-E6-controlled hub; a status of Disabled
indicates that source address traps have been disabled for all ports on all modules;
and a status of Other indicates that there is some combination of enabled and
disabled source address traps on the modules and/or ports in the hub or device.
To change the current status and enable or disable traps for all ports in the EMM-
E6-controlled hub:
1. Click mouse button 1 on the appropriate option in the Source Address Traps
field.
2. Click button 1 on to set your new trap status; the new status will
be displayed to the left of the options in the Source Address Traps field. Note
that enabling or disabling traps at the repeater level will eliminate any status of
Other by setting all ports on all modules to the same status.