Filter
Top Products
Source Addressing
6-10 Configuring Source Address Traps
Figure 6-3. The Module Source Address Traps Window
To enable or disable port-level traps:
1. In the Port Source Address Traps window (Figure 6-4, below), click mouse
button 1 to select the port or ports for which you wish to enable or disable
traps. If the Set Trap Status For field displays
Selected Ports
(the default
setting), you can click to select any ports; to de-select any highlighted port,
click on it again. If the selection
All Ports On Module
is displayed in the Set
Traps Status For field, you can select only one port at a time; trap status will
be set for all ports on the same module as the selected port. If the selection
All Ports on Repeater
is displayed in the Set Trap Status For field, all
available ports will be automatically selected; if you de-select any port, the
Set Trap Status For field will automatically revert to the
Selected Ports
setting. To change the setting in the Set Trap Status For field, click mouse
button 1 on the currently displayed setting, and drag down to select a new
setting.