Filter
Top Products
Finding a Source Address 6-11
Source Addressing
Figure 6-4. The Port Source Address Traps Window
2. Click on the appropriate selection in the Trap Status field to enable or disable
traps for the selected port(s), as desired.
3. Click on to save your changes.
Finding a Source Address
You can use the button to locate a source address in the list by the
module and port through which it is communicating with the EMM-E6. This
feature is especially useful when your device is very busy and your source
address table is quite large.
To find a source address:
1. Click mouse button 1 on in the Source Address List window
(Figure 6-2, page 6-3); the Find Source Address window, Figure 6-5, will
appear.
NOTE
Note that each repeater channel maintains its own Source Address Table, and they are
completely independent of one another; therefore, if you search for a source address
communicating via Channel B from the Channel A Source Address List window, the
result will be a “not found,” even though the address is connected to a port in the EMM-
E6-controlled hub.