Cabletron Systems SEHI-32 Switch User Manual


 
INSTALLATION
Page 3-1
CHAPTER 3
INSTALLATION
This chapter outlines the procedure for installing the SEHI to your
network as a stackable or stand-alone device. Ensure that your
network meets the guidelines and requirements outlined in Chapter 2,
Installation Requirements/Specifications, before installing the
SEHI.
3.1 UNPACKING THE SEHI
Unpack the SEHI as follows:
1. Remove the shipping material covering the SEHI in the shipping
box.
2. Carefully remove the SEHI from the shipping box and set it aside
to prevent damage.
3. Visually inspect the SEHI. If there are any signs of damage,
contact Cabletron Systems Technical Support immediately.
4. Read the SEHI Release Notes included in the shipping box.
Note: Cabletron Systems includes a 3-1/2" disk with the SEHI. This
disk contains a backup copy of the SEHI’s Flash Firmware Image File.
You can download the backup image file to the SEHI if the existing
image becomes corrupted.
3.2 INSTALLING THE SEHI
You can install the SEHI to your network as a stackable or
stand-alone hub. If you want to install the SEHI on a wall or a 19-inch
rack, Cabletron Systems offers an accessory kit that includes Rack
Mount Brackets, Wall Mount Brackets, Mounting Screws, and a Strain
Relief Bracket. The accessory kit is not included with the SEHI, but
you can purchase it separately from Cabletron Systems as Part
Number SEHI-ACCY-KIT.