Filter
Top Products
Back Previous Page Next Page
Contents
DR-2010C / DR-2510C
DR-2010C / DR-2510C
65
To clean or replace the feeding roller, retard roller, or document holding guide,
remove and then attach the parts as described in each respective section.
CAUTION
Do not use excessive force when removing or attaching the rollers and
document holding guide. Doing so many damage them.
When the rollers have fed more than 30,000 pages, a roller replacement
message appears on the computer. Purchase an exchange roller kit and replace
the feeding roller and the retard roller.
IMPORTANT
• Rollers are consumable parts. When the rollers start to wear out, paper jams
and misfeeds may occur more often. When this happens, purchase an
exchange roller kit and replace the feeding roller and the retard roller.
• If misfeeds occur often, check the rollers for wear, and replace them if
necessary before the message is displayed.
• Make sure to reset the counter after replacing the rollers (See "Resetting the
Counter," on p. 70.).
• For information about the exchange roller kit (feeding roller, retard roller,)
contact your local authorized Canon dealer or service representative.
To remove or attach the feeding roller, follow the procedure below.
CAUTION
Use caution when removing or attaching the feeding roller. Using excessive
force may cause damage or personal injury.
Removing the Feeding Roller
1
Open the document feed tray (See p. 20).
2
Press the OPEN knob from both sides (c), and pull the front unit out and
downward to open it (
d).
Roller Replacement Cycle
2. Removing and Attaching the Rollers and Document Holding Guide
2
2.
Removing and Attaching the Rollers and Document Holding Guide
Removing
and
Attaching
the
Rollers
and
Document
Holding
Guide
Removing/Attaching the Feeding Roller
d
c