Filter
Top Products
117
3 Setting the FlashN
Shutter sync.
Normally, set this to [1st curtain] so that the flash fires immediately
after the exposure starts.
If [2nd curtain] is set, the flash will fire right before the exposure
ends. When this is combined with a slow sync speed, you can create
a trail of light such as from car headlights at night. With 2nd curtain
sync, two flashes will be fired, once when you press the shutter
button completely, and once immediately before the exposure ends.
However, with shutter speeds faster than 1/30 sec., the 1st curtain
sync will automatically take effect.
If an external Speedlite is attached, you can also set [Hi-speed]. For
details, see the Speedlite’s instruction manual.
Flash exposure compensation
See “y Flash Exposure Compensation” on page 113.
E-TTL II
For normal flash exposures, set it to [Evaluative].
If [Average] is set, the flash exposure will be averaged for the entire
metered scene as with an external metering flash. Since flash
exposure compensation may be necessary depending on the scene,
this setting is for advanced users.
Wireless setting
See “Using Wireless Flash” on page 119.
Clear flash settings
With the [Built-in flash func. setting] or [External flash func.
setting] screen displayed, press the <B> button to display the
screen to clear the flash settings. When you select [OK], the settings
for the flash will be cleared.
To prevent the flash from overheating and degrading, avoid firing the MULTI
flash more than 10 consecutive times. If you fire the flash 10 times, allow the
flash to rest for at least 10 min. before firing the flash again. Some EX-series
Speedlites will automatically stop firing after 10 times to protect the flash. If
this happens, let the flash rest for at least 15 min.
COPY