Filter
Top Products
243
If a problem occurs, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
If the battery’s remaining capacity (p.230) is 94% or higher, the battery
will not be recharged.
Do not recharge any battery pack other than genuine Canon Battery Pack LP-E6.
If there is a problem with the battery charger or battery pack or if
communication with the battery pack (non-Canon battery packs) is not
possible, the protective circuit will terminate the charging and the orange
lamp will blink quickly at a regular interval. If there is a problem with the
battery charger or battery pack, unplug the charger’s power plug from the
power outlet. Detach and reattach the battery pack to the charger. Wait 2
to 3 minutes, then reconnect the power plug to the power outlet. If the
problem persists, contact your dealer or nearest Canon Service Center.
If the internal temperature of the battery pack attached to the charger is
high, the charger will not charge the battery for safety reasons (lamp
off). During the charging, if the battery’s temperature becomes high for
any reason, the charging will stop automatically (lamp blinks). When the
battery temperature goes down, the charging will resume automatically.
The battery is not properly installed in the camera (p.26).
Recharge the battery (p.24).
Make sure the battery compartment cover is closed (p.26).
Make sure the card slot cover is closed (p.29).
Troubleshooting Guide
Power-Related Problems
The battery pack does not recharge.
The charger’s lamp blinks at high speed.
The charger’s lamp does not blink.
The camera does not operate even when the power switch is set to <
1
>.
COPY