Filter
Top Products
Caution
• Always grip the plug to remove the power cable from the power outlet. Pulling on the power cable could damage the
cable and lead to a fire or electrical shock.
• Never use an extension cord. This could cause a fire or electrical shock.
• Never use any power source other than 100–120 / 220–240 V AC. This could cause a fire or electrical shock. The
printer operating conditions are described below. Use the printer under the following conditions.
Power supply voltage: 100–120 / 220–240 V AC
Power supply frequency: 50/60 Hz
In an Emergency
Warning
• If the printer emits smoke or strange odors, continuing to use the printer may cause a fire or electrical shock. Switch the
printer off immediately and remove the power plug from the power outlet. Contact the nearest service center.
Cleaning the Printer
Warning
• For cleaning, use a cloth dampened in water. Never use flammable solvents such as alcohol, benzene, or thinner. If
these substances come into contact with electrical components inside the printer, there is a risk of fire or electrical
shock.
Caution
• Always disconnect the power cable from the outlet before cleaning the printer. If the printer is switched on accidentally,
moving parts inside the printer may cause personal injuries.
Pacemakers
Warning
• This printer generates a low-level magnetic field. Anyone wearing a pacemaker who experiences discomfort while work-
ing around the printer should leave the area. Consult a physician before continuing to work around the printer.
Moving the Printer
Caution
• Moving the printer requires at least six people, holding it on both sides. Be careful to avoid back strain and other inju-
ries.
• When moving the printer, firmly grasp the Carrying Handles under each side. The printer may be unsteady if you hold it
at other positions, which poses a risk of injury from dropping the printer.
Printhead, Ink Tanks, and Maintenance Cartridge
Caution
• Always store consumables in a safe location out of the reach of small children. If a child licks or ingests ink accidentally,
seek medical assistance immediately.
• If ink accidentally gets in your eyes, immediately rinse with water.
If ink gets on your skin, immediately clean it off with soap and water.
If irritation persists in your eyes or on your skin, contact a physician immediately.
• Avoid dropping or shaking printheads, ink tanks, and maintenance cartridges. Spilled ink can stain clothing and the work
area.
• Never touch the electrical contacts of the Printhead after printing. The contacts become extremely hot and can cause
minor burns.
iPF8400
Safety Precautions
Basic Guide
Preface Safety Precautions
3