Filter
Top Products
20
3.
Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
ᕡ Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a POWER button.
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off (
⅜
)
position. Failure to do so may cause damage to the projector.
A
C
IN
Z
O
O
M
F
O
C
U
S
WARNING
LAMP REPLACE
POWER
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page 52 for more
details.
2. Press the POWER button on the projector cabinet or
the POWER button on the remote control for a
minimum of 2 seconds. The POWER indicator will
turn to green and the projector will become ready to
use.
After you turn on your projector, ensure that the
computer or video source is turned on and that your
lens cap is removed.
NOTE: When no signal is available, a blue, black or logo screen is
displayed.
When the projector displays a blue or a black screen (not logo),
the Quiet mode will be automatically selected in "Lamp Mode."
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans runs without
displaying an image for some time and then the projector will
display the image.
POWER
VIDEO S-
VIDEO
WARNING
LAMP REPLACE
VOL
-
VOL
+
POWER
OFF
NO SHOW
D.ZOOM
PAGE
MENU
POWER
POWER
WARNING
LAMP REPLACE
WARNING
LAMP REPLACE
POWER
WARNING
LAMP REPLACE
Standby Blinking Power On
Steady orange light Blinking green
light
Steady green
light
See page 52 for more details.