Canon LV-8320 Projector User Manual


 
50


Use the Point ▲▼ buttons to enter a number.
Press the Point ◄► buttons to fix the number
and move the red frame pointer to the next
box. The number changes to . If you fixed an
incorrect number, use the Point ◄► buttons
to move the pointer to the number you want to
correct, and then enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the
pointer to . Press the OK button so that you
can start to operate the projector.
If you entered an incorrect Logo PIN code, 
 and the number () will turn red
for a moment. Enter the correct Logo PIN code
all over again.

Logo PIN code can be changed to your desired
four-digit number. Press the OK button to select
. Current 
dialog box appears, use the Point ▲▼buttons to
enter the current code. The New logo PIN code
input dialog box appears. Set a new Logo PIN code,
confirmation box appears, choose  to set the
new Logo PIN code.
Be sure to note the new Logo PIN code and keep it
on hand. If you lost the number, you could no longer
change the Logo PIN code setting.
Use the Point ▲▼ buttons to switch On or ,
and then press the OK button to make a choice.


After a correct Logo PIN code
is entered, the following dialog
box appears.










If you forget your Logo PIN code and unable to
change it, the Logo PIN code can be reset to the
factory default setting (4321) according to the
following procedures.
When you reset the Logo PIN code, the PIN code
and Key lock will be reset, as well.
1. Unplug the AC Power Cord from the AC outlet.
2. Hold down the OK button on the projector and
connect the AC Power Cord into the outlet again.
Keep holding down the OK button until the POWER
indicator lights. The Logo PIN code returns to the
factory default setting while the Logo PIN code lock
state will remain the same as the previous set
state.