Canon LV-8320 Projector User Manual


 
54


This function is available when operating the
projector via network.
 .. Supply the power to the network
function even after turning off the
projector by pressing the POWER
button on the remote controller.
You can turn on/off the projector
via network, modify network
environment, and receive an
e-mail about projector status while
the projector is powered off.
 ......... Select  when you do not use
the projector via network. The
projector’s network function will
stop when turning off the projector.
Refer to the user’s manual of “Network Set-up
and Operation”.

When selecting , the cooling fans may
be running depending on the temperature inside
the projector even if the projector is turned off.
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
 ....... The P-timer display 
appears on the screen and the
count up starts ()
 .. The time set in the Timer setting
appears on the screen and the
countdown starts.
 ............. Use the Point ▲▼ buttons to set
the Timer ().  is
available in Count down only.
Factory default value is 10 Min.
 ............... It executes the count up or count
down function. Press the OK
button at  and the indication
changes into Stop. To stop
 or , press
the OK button at on the
screen menu, then the indication
changes into Restart. Press the
OK button at Restart to resume
 or .
Reset ............. Reset the P-timer values.
Press the OK button at Reset
to return to the following value:
 ........ "000:00"
 ... Timer that
you set
 ................ To exit the P-timer operation.

P-timer display

To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.

X: disabled O: enabled
*1 When  is selected, it is only possible to turn on the
projector while using the RS-232C serial port.
*2 When switch the Standby MIC out function On and in
Standby mode status, only MIC volume can be output.
Monitor Out
Audio Out
Direct power on
Serial command
Network
*1
*2