Filter
Top Products
36 Troubleshooting
“The Card Slot is already mapped as Network Drive to this computer.”
is displayed
“Cannot map any more drives, because all the drive letters are
assigned.” is displayed
The network setup of the Card Slot
fails.
(Continued)
z Change the workgroup name to “WORKGROUP” following the procedure
below.
(1)Right-click My Computer, then select Properties.
(2)Select the Computer Name tab, then click Change.
(3)Change the workgroup name to “WORKGROUP”, then click OK.
If the problem is not resolved, click Skip to complete the installation without the
network setup of the Card Slot. After installation is complete, to mount the Card
Slot using the Canon IJ Network Tool, refer to “Using the Card Slot over a
Network” in the User’s Guide on-screen manual. To mount the Card Slot
manually, refer to “Cannot Mount the Card Slot” in “Troubles When Using the
Machine over Network” in “Troubleshooting” of the User’s Guide on-screen
manual.
z Make sure that a memory card is inserted in the Card Slot. If it is not inserted,
insert it.
Note
Depending on the Mac OS version, the authentication screen may appears.
If it appears, click OK.
If the problem is not resolved, click Skip to complete the setup without the
network setup of the Card Slot. To mount the Card Slot manually, refer to
“Cannot Mount the Card Slot” in “Troubles When Using the Machine over
Network” in “Troubleshooting” of the User’s Guide on-screen manual.
Cause Action
The Card Slot has already been
mapped as the network drive.
The Card Slot is already available. Click OK to close the dialog, then click Next
on the Network Setup of the Card Slot dialog box.
Cause Action
All drive letters are assigned. Click Skip to complete the setup. After software installation is complete, remove
any drive letter and try the network setup of the Card Slot again using the
Canon IJ Network Tool. For details, refer to “Using the Card Slot over a
Network” in the User’s Guide on-screen manual.
Cause Action