Filter
Top Products
72
SETTING UP FUNCTIONS USING MENUS
Set a password in the projector. Once the
password is set, you will need to enter the
password each time you turn on the
projector.
The password function is not
used.
The password function is
used.
• Once a password is set in the
projector, a password entry screen
appears at power-on. Enter a 4-
digit password using [^], [v], [<],
and [>] buttons. If the password is
valid, projection starts. If you enter
a wrong password three times, the
projector will be turned off.
• To cancel the password, remove
the power plug from the AC outlet
after completion of projection, and
then insert the power plug in the
AC outlet with the [MENU] button
pressed.
Setting a
Password
When you use two projectors at the same
time, change the channel settings to
prevent the two remote controls from
interfering with each other.
Select the channel on the
projector you use, and then
press the [OK] button.
Selecting a Channel for the Remote Control
While pressing the [OK] button on the remote
control, press the [LIGHT] button for 3
seconds.
Pressing the two buttons allows you to switch
between CH1 (the button flashes once) and
CH2 (the button flashes twice).
• When setting a channel, be sure to
set the same channel for either
control (remote control or top
control). Set a different channel for
the other pair.
• When performing menu operation
using the remote control, changing
the channel by pressing the [OK]
button will prevent you for using
the remote control.
Setting up the
Remote Control
System settings
Password settings
System settings
Remote control
Off
On
Ch1
Ch2