Filter
Top Products
E-26
Handling the Hand Strap
A hand strap can be attached to the Handheld Printer Terminal.
Hook A
Release buttons
Hand Strap
Hook B
Attach the hand strap following the procedure described below.
1. Attach Hook B of the hand strap to the
hand strap hook located on the bottom
of the Handheld Printer Terminal. (On
models with a magnetic card reader,
the hook is located at the bottom of the
terminal on the back of the reader.)
2. Pull on the hand strap in the direction
shown in the illustration, and then fasten
Hook A onto hook (
1
) on the back of
the Handheld Printer Terminal.
3. Fasten the wire of Hook A by inserting
into the indentation in the Handheld
Printer Terminal.
Pull up on the center of the wire when
unfastening.
Press the left and right release buttons to
separate the strap.
Important!
When installing or removing the battery pack, always remove the hand strap
fi rst. Pulling on the hand strap with excessive force could cause damage.
•
•
•
* The illustration shows the IT-9000-20E.
1
* The illustration shows the IT-9000-20E.
1