Filter
Top Products
29
IV. Hardware Setup
IV. Hardware Setup
AP8000 Hardware Reference Guide
The SCSI backplane of this server is comprised of two SCSI backplane
boards with a 68-pin SCSI connector, power input, and SCSI ID dip
switches on each SCSI backplane board. This configuration allows
Ultra2 or Wide-SCSI hard disk drives to be docked into the server
using a common connector. The female end is located on the SCSI
backplane board, while the male end is located on the hot-swap tray.
• 4-10. SCSI Backplane
SCSI Backplane
The DA-BP4 SCSI backplane board has automatic termination.
If using Ultra-wide devices, make sure the termination on each
device is disabled.
IMPORTANT
SCSI Backplane Board Back Side
68-pin Ultra2 or Wide-SCSI Connector
SCSI Backplane Board
Power #1
SCSI Terminator
SCSI ID Dip Switches
SCSI Backplane Board
Power #2
68-pin Ultra2 or Wide-SCSI Connector