Filter
Top Products
6
18. Locate the cigarette lighter outlet wiring harness.
19. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be sold ered/spliced.
20. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
21. Solder the supplied fused pigtail to Wi-Fi power har-
ness po we r wire.
22. Place the strands of the power side wires overlapping
each other ins ide of the splice clip (1 ).
23. Using crimping tool (1), Mopar® p/n 05019912AA or
equivalent, crimp the splice clip and wires together.
24. Repeat the previous two steps for the ground side
wires.
Aug 08, 2008 K6860631 Rev. 1